Image 1 of 1
The CB12245AJ charger has an ultra-compact design, only 45mm wide, which minimizes the space required inside the cabinet. The module is dual voltage selectable, 12V and 24V, with a charging current of 6A at 12V and 5A at 24V.
The CB12245AJ has the CANBUS J1939 communication protocol which allows monitoring of more than 50 parameters regarding the status of the charger and connected batteries. CAN communication can be enabled via the connector on the front of the product.
Through the new multicolored LED, the CB60 series warns of battery defects: reverse polarity, incorrect battery voltage, battery not connected, and battery with shorted cells.
The charger is equipped with the "Power Supply" feature, which enables it to activate the power function to provide power even when the battery is disconnected. The device, with mains input present, provides power to the connected load like a power supply unit.
Key Features
Selectable output voltage 12V and 24V
Charging with constant voltage and current (Lead, AGM, Gel, Ni-Cd, Li-Ion and LiFePO4).
Relay output for battery failure signaling
Extremely small size
Output current up to 6AMP
Canbus Communication Protocol J1939
Protection against short circuit, overload, output overvoltage, polarity reversal
Temperature range -25 to 70°C
Products
Battery Charger 12/24Vdc
-
Input: Single-phase 115 – 230 - 277 Vac
Output Jumper Selectable: 12 Vdc 6A; 24 Vdc 5 A
Power Supply Function: setting by Jumper
Suited for the following battery types: Open Lead Acid, Sealed
Lead Acid, lead Gel, Ni-Cd, Li-Ion (option)
Battery Care for automatic diagnostic of battery status, short
circuit element
Charging curve IUoU, constant voltage and current
Switching technology Semi-resonant
Charging type: Boost, Absorption, Float, Recovery.
Protected against short circuit, inverted polarity, over Load.
Signal output (contact free) for fault battery state
Protection degree IP20 - DIN rail
CANBus J1939